Muzzle Brake Thread
Caliber for bore diameter
Our top of the line muzzle brake offering the greatest reduction in muzzle rise and recoil. This brake will tame the fiercest recoil enabling your most accurate shots. The fluted face of the X-Terminator Muzzle Brake can be used for breaching doors and barbed wire fences. Length: 2 1/2"
X-Terminator Muzzle Brakes should be properly timed with a crush-washer, peel-washer or muzzle device shim kit (not-included) so the "X-Terminator" logo is centered at the bottom (6 o'clock) and the opposing 4 gas ports are centered at the top (12 o'clock).
Check out the X-Terminator muzzle brake in action!!
The video shows a 10" .308 Win AR Pistol with no brake, followed by an A2 Birdcage (which are everywhere), and finally our X-Terminator Muzzle Brake. It blew our expectations out of the water!!
Stainless Steel and .980" OD only
NOT INTENDED FOR BARRELS UNDER 10" LONG THAT ARE .375cal AND LARGER FIRING MAX-PRESSURE LOADS--DAMAGE TO BRAKE MAY OCCUR IN THESE TYPES OF CONFIGURATIONS, USE AT YOUR OWN RISK!
1 Week lead time
No shipping outside the US
NOTE: Regarding the 3/4"x24 and 49/64"x20 thread patterned X-Terminator Muzzle Brakes; as these two thread sizes on this brake do not have wrench flats for installation like the other thread sizes of X-Terminator Brakes, we recommend installation via a properly-sized strap wrench used around the outside of the brake.
or for only 1/2x28 crush washers:
For peel-washer and shim kits:
NOTE: Due to variance in manufacturers' sand-blasting media from lot to lot, we cannot guarantee that the matte finish option will match your barrel's matte finish unless they are ordered at the same time on the same order.
Unturned Blanks 2-4 Weeks
Contoured Blanks 4-6 Weeks
Prefits 6-8 Weeks
ARs 8-10 Weeks